PAIEMENT EN 4 FOIS
TESTÉ ET APPROUVÉ
If you want to install a saddle with a raised rear or change the shape of your motorcycle, this product is ideal .
The buckle is a part to be attached to the rear of the motorcycle to close the frame.
This makes it possible to make the rear part of the motorcycle more aesthetic.
The angle of inclination is approximately 20°.
The rear motorcycle buckle is made by hand in steel . The steel is untreated. This model measures 22 or 25 mm in diameter.
Please note that the width is not measured at the center distance but the external width is the widest distance.
The model is available in widths: 175, 195, 215, 225, 235, 250 and 270 mm.
The raised motorcycle rear loop is perfect for giving a beautiful rear line to the motorcycle.
The motorcycle rear buckle is ideally installed by being welded to the frame or to the original buckle.
Here is an illustration of a short loop:
The dimensions expressed correspond to the following dimensions:
Attention: The width expressed is the external width, distance between the ends of each side.
Diameter: 22 or 25 mm
Length: +/- 20cm
The buckle is raw, it may have surface rust. This does not prevent its proper use.
Product to order.