Long and raised scrambler rear buckle. 22 or 25 mm

• Handle
• Steel
  

Presentation of the long and raised scrambler back loop

If you want to install a saddle with rear noted or modify the form of your motorcycle, this product is ideal. 

There loop is a part to fix at the back of the motorcycle to close the frame.

This makes it possible to make the rear part of the motorcycle more aesthetic.

There Scrambler rear buckle is made by hand in steel. Steel is untreated. It is available in diameter 22 Or 25 mm and in several different widths.

Be careful, the width is not measured at the extent but the external width either the distance to the widest.

The model is available in width: 175, 195, 205, 215, 225, 235 and 250 mm. 

There Long and raised rear scrambled backpin is ideal if you want to install a flat saddle or modify a biscornu frame with a more classic line.

There Scrambler back loop Ideally settled by being welded in the original frame or loop.

You can tighten the parts at the end to match your chassis.

We can make the loop longer If you wish (a supplement may be requested depending on the length to cover additional shipping costs).

Here is an illustration of a short loop:

The dimensions expressed correspond to the following dimensions:

Attention : The width expressed is the external width, a distance between the ends on each side. 

Features:

• Material: Steel 
• Color: Brut
• Diameter: 22 mm / 25 mm 
• Length: +/- 55 cm 

Note :

The loop is raw, it can have superficial rust. This does not prevent its good use. 

This product is made at the order.