RECHERCHE PAR CATEGORIES
  • RECHERCHE PAR INSPIRATIONS
  • RECHERCHE PAR MARQUES DE MOTO
  • Cafe racer remote controls

    21873

    • In aluminum 6061
    •  Quality finish
    • Non-slip footrest
    • Rubber lever tip to avoid damaging shoes. 
    • Sold in pairs

    4-INSTALLMENT PAYMENT

    TESTE ET APPROUVÉ

    TESTED ET APPROVED

    SATISFACTION 100%

    SATISFACTION GUARANTEED

    With the bracelet handlebars, the remote controls Cafe Racer are essential elements in the transformation of a motorcycle into Racer coffee.

    THE Cafe racer remote controls are located further back and higher than original footrests, which allows the driver to adopt a more aggressive and more sporty driving position

    The Cafe Racer style was born in the United Kingdom in the 1950s and 1960s and was popularized by young drivers who wanted to modify their motorcycle for speed and style. Racers cafes generally have a stripped appearance, with a low handlebars, a shell saddle and a minimum body. They are known for their agile handling and rapid acceleration.

    The addition of Cafe racer remote controls on a motorcycle allows the driver of move your weight forward, which can Improve the handling and the handling of the motorcycle. However, this can also make the driving position more uncomfortable, because the driver's legs are positioned higher and further back than on a standard motorcycle in a pure Racer coffee. 

    THE Cafe racer remote controls proposed here are made in aluminum of type 6061. They have non-slip footrest and ofRubber lever tips To avoid damaging shoes. 

     

    How to install remote controls on your motorcycle? 

    1. Remove the original controls and the supports. 
    2. Plan the position of the remote controls.
    3. Make a plan of the support decks. The remote controls will be fixed on these decks. 
    4. The original locations are generally used. 
    5. Define the length of the connections. The connecting rods are the link between the remote controls and the engine to activate the passage of the speed, as well as the rear master cylinder for braking.
    6. Make the plate. It can be a simple hole plate and cut in 5mm steel. 
    7. Install the whole.
    8. Test and adjust. 

     

    We can make the decks for you and provide you with the connecting rods. To do this, make a plan and contact us.